Location -> News
News
Coriolis flow meter for post-combustion gas
Email: sales01@cxflowmeter.com
WhatsApp: 008618049841995
Customer inquiries on the selection of Coriolis mass flowmeter for post-combustion gas
Overview of customer needs:
Medium: post-combustion gas, whose bulk density is 1.1-1.2 times that of air.
Range: 10slm (under zero pressure pneumatic conditions).
Pressure requirement: 1MPa.
Temperature requirement: 200℃ or 160℃.
Tube diameter connector: 6mm ferrule type.
Communication signal: RS485.
Analog signal output: 4-20mA (default).
Power supply: 24VDC.
Display function: required.
Accuracy requirement: 1%fs.
Application background:
The customer plans to burn oil, clothes, wood chips and various daily necessities in the experimental chamber, and then extract and analyze the gas produced by the combustion.
Since the type of combustion material is uncertain, the composition of the gas produced after combustion cannot be predicted. It is recommended to calculate it according
to 1.1~1.2 times the bulk density of air.
Since the type of combustion material is uncertain, the composition of the gas produced after combustion cannot be predicted. It is recommended to calculate it according
to 1.1~1.2 times the bulk density of air.
Technical advice:
Our technicians recommend the use of a high-temperature split Coriolis mass flowmeter based on customer needs. This flowmeter can meet the needs of measuring post-combustion gas as air.
If you have similar flowmeter selection needs, please feel free to contact us:
Contact: Winny
Email: sales01@cxflowmeter.com
WhatsApp: 008618049841995
Last：Selection of magnetic flap leve.. Next：Hot melt adhesive metering pump
